Biokube
| Business category 1 | Water Treatment |
| City ( of main office ) | Næstved, DK, Denmark |
| Address | bakkevej 3 |
| Phones | 45-40113401 |
| Fax | 45 |
| About | Dear S. Begheri I have been contacted by Peter Hedegaard concerning production of curcuit boards. We need a board that can do the following: This is our requirements to the board: - Power supply: 230 V 50 Hz - 2 Terminals for 1000 W pump that must run according to an in-board timer And at the same time in case of high level to a level switch (there must be a terminal for Input from levelswitch-if possible from an inductive / magneting switch) - 2 Terminals for level switch input (see above) - 2 Terminals for 500 W blower - 2 Terminals for magnet valve that must be activated 1-60 sec every 1-60 Min in repeated cycles. - 2 Terminals for a 100 W pump that must be activated 1-60 sec. Every 1-60 min in repeated cycles. - 2 terminals for alarm signal out of the unit giving 230 V 50 Hz max 500 W each. We would like the print to measure max 90x90 mm and not being too sensitive to moisture. The timers setting must be stored so a power failure will not need a new programming of the timers and the unit being able to start up when power is back. The terminals must be easy to make cable connections to. What will your time and delivery estimate be on a product like this if we buy 1. 000 pieces per year? Best regards Mikael Nielsen Biokube Denmark |
| Date | 2011 Oct 29, 11:10 |